ANNEX to the COMMISSION REGULATION (EU) …/… amending Regulation (EU) 2024/1834 as regards definitions, transitional provisions, verification tolerances, test results corrections and other provisio...

Ref. Ares(2024)9083227 - 18/12/2024 EUROPEAN COMMISSION ANNEX to the COMMISSION REGULATION (EU) …/… Brussels, XXX […](2024) XXX draft ANNEX amending Regulation (EU) 2024/1834 as regards definitions, transitional provisions, verification tolerances, test results corrections and other provisions that relate to fan speed ANNEX Annexes I, II, III and IV to Regulation (EU) 2024/1834 are amended as follows: (1) Annex I is amended as follows: (a) point (36) is deleted; (b) the following points (40) and (41) are added: ‘(40) ‘tip speed’ (utip), in m/s, means the peripheral speed of the impeller blade tips; (41) ‘impeller diameter’ (Dimpeller), in mm, means the maximum diameter measured over the tips of the blades of the impeller.’; (2) Annex II is amended as follows: (a) after the heading ‘ECODESIGN REQUIREMENTS FOR FANS’, in the second paragraph, the introductory sentence is replaced by the following: ‘However, until 24 July 2037, spare part fans replacing either fans placed on the market before 24 July 2026, or which replace fans integrated into products and complying with all criteria under (a) to (d) above, are exempt from the requirements set out in points 1 to 5, provided that:’; (b) point (2)(2)(l) is replaced by the following: ‘(l) inherent speed at BEP or Tm (in rpm, rounded to the nearest integer)’; (c) in point (3)(1), first paragraph, the second sentence is replaced by the following: ‘This shall be described by a...